Applicable Plc; Connection With Plc - Mitsubishi Electric MELSEC-F Series User Manual

FX -1PG User's Manual
3U
3.2

Applicable PLC

Model name
FX Series PLC
3U
FX Series PLC
3UC
The version number can be checked by reading the last three digits of device D8001/D8101.
*1. An FX
2NC
3.3

Connection with PLC

The FX -1PG connects to a PLC via an extension cable.
3U
The FX -1PG is handled as a special extension block of the PLC. The unit number of the FX
3U
automatically assigned No. 0 to No. 7 (Unit No. 1 to No. 7 is assigned when the main unit is an FX
LT(-2).) starting from the special function unit/block closest to the PLC main unit.
(This unit number is used in FROM/TO instructions.)
For details on the assignment of the I/O number and unit number of the PLC, refer to the following manual
corresponding to the connected PLC.
FX PLC
3U
Other
extension
FX PLC
3UC
units/blocks
FX -CNV-IF
2NC
• An FX -CNV-IF or FX
2NC
• For extension, the separately available FX
used. One extension cable can be used per system.
• The number of I/O points occupied by the FX
(occupied I/O points) of the main unit, extension unit(s), extension block(s) and the number of points
occupied by special function blocks does not exceed the maximum number of I/O points of the PLC.
For information on the maximum number of I/O points of the PLC, refer to the respective product manual.
20
Ver. 2.20 and later
*1
Ver. 2.20 and later
-CNV-IF or FX -1PS-5V is necessary to connect the FX
3UC
FX
FX -1PG
3U
-1PS-5V is necessary to connect the FX
3UC
Applicability
Other
extension
-1PG
3U
units/blocks
-65EC/FX -30EC extension cable and FX
0N 0N
-1PG is eight. Make sure that the total number of I/O points
3U
3 System Configuration
3.2 Applicable PLC
Maximum number of connectable units
8 units
6 units
-1PG with the FX
3U
→ Refer to FX
Hardware Edition.
3U
→ Refer to FX
Hardware Edition.
3UC
-1PG to the FX PLC.
3U 3UC
-CNV-BC are
2N
→ Refer to FX
Hardware Edition.
3U
→ Refer to FX
Hardware Edition.
3UC
PLC.
3UC
-1PG is
3U
-32MT-
3UC