General Specifications; Power Supply Specifications; Performance Specifications - Mitsubishi Electric MELSEC-F Series User Manual

FX -1PG User's Manual
3U
2.1

General Specifications

Items other than the following are equivalent to those of the PLC main unit.
For general specifications, refer to the manual of the PLC main unit.
Item
Dielectric withstand voltage
Insulation resistance
2.2

Power Supply Specifications

Input signal
Drive power
Output signal
supply
Inner control
2.3

Performance Specifications

Number of control axes
Positioning program
Positioning
Number of I/O occupied points
*1. For details of other applied instructions and methods, refer to the FX
Programming Manual.
16
500 V AC for one minute
5 MΩ or higher by 500 V DC insulation
resistance tester
Item
24 V DC ±10%
Current consumption 40 mA or less
For pulse output: 5 to 24 V DC Current consumption 35 mA or less
For CLR signal: 5 to 24 V DC Current consumption 20 mA or less
5 V DC Current consumption 150 mA
(Power is supplied through the extension cable from the PLC.)
Item
One axis
Created by sequence programs (using FROM/TO instruction or direct specification of
the buffer memory etc. on the MOV instruction etc.
Method Increment, Absolute
Unit
PLS, μm, 10
Unit magnification 1, 10, 100, 1000-fold
Range -2,147,483,648 to 2,147,483,647 PLS
Operation speed Hz, cm/min, inch/min, 10deg/min
Output frequency 1 Hz to 200 kHz
Trapezoidal acceleration/deceleration:
Acceleration/ 1 to 32,767 ms
deceleration process Approximate S-shaped acceleration/deceleration:
1 to 5,000 ms
Motor system: 1 ms or less
Starting time
Machine system: 2 ms or less
8 points
(taken from either the input or output points of the PLC)
→ Refer to FX
→ Refer to FX
Specification
Between all terminals and ground terminal
Specification
Specification
-4
inch, mdeg
2 Specification
2.1 General Specifications
Hardware Edition.
3U
Hardware Edition.
3UC
*1
)
/FX /FX /FX /FX
3S 3G 3GC 3U 3UC