Section 9 — Axles and Brakes
Axle and Drive Shaft Component Terminology
General Information
31200079
To understand the safety, operation and maintenance information
presented in this section, it is necessary that the operator/mechanic be
familiar with the names and locations of the major assemblies of the axles
and drive shafts. The following illustration identifies the components that
are referred to throughout this section.
FRONT STEERING
CYLINDER
FRONT AXLE
ASSEMBLY
IMPORTANT: To help ensure optimum performance, the drive shaft assemblies
are specially balanced as a unit at the factory. When servicing any flange yoke,
slip yoke or drive shaft tube, order a complete assembly if components are bent or
damaged. Refer to the appropriate parts manual for ordering information.
Before performing any inspection, maintenance or service operation,
thoroughly clean the unit. The axles and drive shafts should be checked
and repaired only by experienced service technicians who are aware of all
safety instructions and particular component features.
TRANSMISSION
DROP BOX
FRONT DRIVE
SHAFT
Fig. 9-1: Axle and Drive Shaft
REAR STEERING
CYLINDER
REAR DRIVE
SHAFT
MV0350
9-1