Installation - JLG Lull 1044C-54 II Series Service Manual

Installation

Roll-Back Hose Tray
31200079
(Ref. Fig. 5-35) The following procedure describes installation of the
roll-back hose tray used in models with mid-inlet hydraulics.
1. Inspect and clean the roll-back hose tray.
2. Place the roll-back hose tray on the two support brackets making sure
it is in the same position as when removed.
3. Secure the roll-back hose tray (Item 8) to the rear hose tray support
bracket with two (2) each flatwashers (Item 11), lockwashers (Item 10),
and button head socket capscrews (Item 9). Tighten as necessary.
4. Secure the roll-back hose tray to the front hose tray support bracket
(Item 3) with two (2) lockwashers (Item 7) and button head socket
capscrews (Item 6). Tighten as necessary.
Supply, Pressure, and Return Hydraulics
5-53