Fig. 8-5: Disconnect The Battery Negative (-) Cable; Fig. 8-6: Drain Transmission Oil - JLG Lull 1044C-54 II Series Service Manual

31200079

Fig. 8-5: Disconnect the Battery Negative (-) Cable

7. Thoroughly clean the transmission and surrounding area, including all
hoses and fittings, before proceeding.
8. Place a suitable receptacle under the transmission drain plug. Remove
the transmission drain plug (2), and allow the transmission oil to drain
into the receptacle.
9. Transfer the used transmission oil into a suitable, covered container,
and label the container as "Used Oil." Dispose of used oil at an
approved recycling facility. Clean and reinstall the transmission drain
plug.

Fig. 8-6: Drain Transmission Oil

10. Remove the engine-to-transmission drive shaft.
11. Remove the transmission-to-axle drive shafts.
12. Remove the hydraulic pump.
1
Transmission
MV0190
2
MV0200
8-7