Boom Hoist Cylinder; Description; Fig. 6-7: Boom Hoist Cylinders - JLG Lull 1044C-54 II Series Service Manual

Boom and Transfer

Boom Hoist Cylinder

Description

6-12

Fig. 6-7: Boom Hoist Cylinders

(Ref. Fig. 6-7) Two (2) boom hoist cylinders are used to raise and lower the
boom. They are attached on one end to the outer boom and the other end
is attached to the transfer carriage/boom cradle near the rear of the
operator's compartment. Daily lubrication of the two grease fittings on
each cylinder is required.
31200079