Removal; Fig. 6-11: Front Carriage Tilt Cylinder Installation - JLG Lull 1044C-54 II Series Service Manual

Removal

Front Carriage Tilt
Cylinder
31200079
# Description
1 Inner Boom Section Pin Boss
2 Lock Pin
3 Lockwasher
4 Capscrew

Fig. 6-11: Front Carriage Tilt Cylinder Installation

(Ref. Fig. 6-11) The following steps are required to remove the front
carriage tilt cylinder.
1. Remove quick attach assembly. See page 6-44
2. Tag and disconnect two (2) hydraulic hoses (Item 6) from connectors
(Item 8). Cap fittings and hoses.
3. Support cylinder (Item 7) with sling(s) and crane, or other suitable
means. Make sure equipment has sufficient capacity to support weight
of cylinder; the cylinder weighs approximately 200 pounds.
1
5
6
8
#
5 Upper Pivot Pin
6 Hydraulic Hose
7 Front Carriage Tilt Cylinder
8 O-ring Connector
Boom and Transfer
2
3
4
7
Description
6-19