Overhaul; Fig. 6-15: Rear Carriage Tilt Cylinder Assembly - JLG Lull 1044C-54 II Series Service Manual

Overhaul

Rear Carriage Tilt Cylinder
31200079
5. Clean hydraulic hose ends with solvent. Attach two (2) hoses (Item 7)
to elbows on each cylinder. Torque hose swivel nuts to 44–48 ft-lbs.
6. If necessary, remove grease fitting cover(s) (Item 8) and grease
fitting(s) (Item 9). Clean and inspect for damage; replace if necessary.
Install grease fitting(s) and covers; torque fitting(s) 1.5 to 3 turns past
finger tight.
7. Lubricate grease fittings with EP lithium based grease.
1
# Description
1 45° O-ring Elbow
2 Cylinder Barrel
3 Setscrew
4 Rod Nut
5 Piston
6 Tube

Fig. 6-15: Rear Carriage Tilt Cylinder Assembly

(Ref. Fig. 6-15) The following steps are required to overhaul the rear
carriage tilt cylinder.
1. Lay cylinder horizontally in a vice or hold it down with a strap wrench.
Hydraulic oil in cylinder will drain out during disassembly. Place a
suitable pan or tray under the cylinder.
2. Remove the two (2) elbows (Item 1) from the manifold block on the
cylinder barrel (Item 2).
3. Remove the setscrew (Item 3).
4. Install a spanner wrench in the two (2) holes in the end of the rod
bearing head (Item 7). Unscrew the rod bearing head.
2
3
7
6
5
#
7 Rod Bearing Head
8 Rod
9 Self-Aligned Bushing
10 Grease Fitting
11 Grease Fitting Cover
Boom and Transfer
4
9
8
10
11
MV0740
Description
6-27