ABB ACH580 Series User Manual page 25

16 ACH580 E-Clipse bypass and packaged drive user manual
Motor connections
Connect the motor cables to the output terminal block as shown on page 17. Also
see Connection and wiring diagrams – Box E-Clipse Bypass on page 10. The motor
grounding conductor can be connected to the ground lug near the terminal block.
Note: Route cables through the cable guides on the left side of the enclosure. Use
separate conduits for input power and motor cables. Follow the guides to separate
the cables from each other.
WARNING! Check the motor and motor wiring insulation before connecting the
ACH580 to line power. Refer to the ACH580-01 Hardware Manual
(3AXD50000044839). Before proceeding with the insulation resistance
measurements, check that the ACH580 is disconnected from incoming line power.
Failure to disconnect line power could result in death or serious injury.
Installation