ABB ACH580 Series User Manual page 154

ACH580 E-Clipse bypass and packaged drive user manual
Except where restricted by the system, all parameters are available for both reading
and writing. The parameter writes are verified for the correct value, and for a valid
register addresses.
Note: Parameter writes through standard Modbus are always volatile i.e. modified
values are not automatically stored to permanent memory. Use bypass parameter
1615 PARAM. SAVE to save all altered values.
The system supports the following Modbus function codes for 4xxxxx registers:
03
06
16 (0x10 Hex)
23 (0x17 Hex)
Actual values
The contents of the register addresses 400005...400012 are
are:
• 400005 and 400006 are specified using drive parameters 58.28...58.29
• 400007...400012 are specified using bypass parameters 58107...58112.
• Read-only values containing information on the operation of the drive.
• 16-bit words containing a sign bit and a 15-bit integer.
• When negative values, written as the two's complement of the corresponding
positive value.
• Scaled as described earlier in
Exception codes
Exception codes are serial communication responses from the drive. The drive
supports the standard Modbus exception codes defined below.
Exception
Code
01
02
03
Function Code
Read holding 4xxxxx registers
Preset single 4xxxxx register
Preset multiple 4xxxxx registers
Read/write 4xxxxx registers
Name
ILLEGAL FUNCTION
ILLEGAL DATA
ADDRESS
ILLEGAL DATA
VALUE
Description
Actual value scaling.
Unsupported Command
The data address received in the query is not allowable. It is not
a defined parameter/group.
A value contained in the query data field is not an allowable
value for the ACH580, because it is one of the following:
• Outside minimum or maximum. limits.
• Parameter is read-only.
• Message is too long.
• Parameter write not allowed when start is active.
• Parameter write not allowed when factory macro is selected.
ACTUAL VALUES
Meaning
Embedded fieldbus
145
and