ABB ACH580 Series User Manual page 134

ACH580 E-Clipse bypass and packaged drive user manual
Instance
ID
BO4
BO5
Note: For Present Value Access Types, R = Read-only, W = Writeable,
C = Commandable. Commandable values support priority arrays and relinquish
defaults.
Binary value object instance summary – Drive
The following table summarizes the Binary Value Objects supported:
Instance
ID
BV0
BV1
BV2
BV3
BV4
BV5
BV7
BV8
BV9
Object Name
RO5 CMD This object controls the output state of
Relay 1. This control requires that drive
parameter 15.10 value = 62 (RO/DIO
control word). Also requires CMOD-01
option.
RO6 CMD This object controls the output state of
Digital Output 1. This control requires
that drive parameter 15.23 value = 62
(RO/DIO control word). Also requires
CMOD-01 option.
Object Name
RUN/STOP ACT This object indicates the drive
Run Status, regardless of the
control source.
FWD/REV ACT This object indicates the
motor's rotation direction,
regardless of the control
source.
FAULT ACT this object indicates the drive's
fault status.
EXT 1/2 ACT This object indicates which
control source is active:
External 1 or External 2.
HAND/AUTO ACT This object indicates whether
the drive is under Hand or Auto
control.
WARNING ACT This object indicates the drive's
warning status.
DRIVE READY This object indicates whether
the drive is ready to accept a
run command.
AT SETPOINT This object indicates whether
the drive is at the commanded
setpoint.
ENABLE ACT This object indicates the System
Enable command status (the
combination of all Run and Start
Interlocks), regardless of the
control source.
Description
Active/Inactive
Description
RUN/STOP
REV/FWD
FAULT/OK
EXT2/EXT1
HAND/AUTO
WARNING/OK
READY/NOT
READY
YES/NO
ENABLE/
DISABLE
Active/ Present Value
Inactive Text Access Type
ON/OFF C
ON/OFF C
Present Value
Text Access Type
R
R
R
R
R
R
R
R
R
Embedded fieldbus
125