ABB ACH580 Series User Manual page 144

ACH580 E-Clipse bypass and packaged drive user manual
Instance
ID
BO3
BO4
Note: For Present Value Access Types, R = Read-only, W = Writeable,
C = Commandable. Commandable values support priority arrays and relinquish
defaults.
BACnet value object instance summary – Bypass
The following table summarizes the Binary Value Objects supported:
Instance
ID
BV0
BV1
BV2
BV3
BV4
BV5
BV6
BV7
BV8
BV9
Object Name
RO4 COMMAND This object controls the output state
of bypass Relay Output 4. This
control requires that parameter
1410 value =
OREL-01 option).
RO5 COMMAND This object controls the output state
of bypass Relay Output 5. This
control requires that parameter
1413 value =
OREL-01 option).
Object Name
SYS RUN ACT This Object indicates the system
run status regardless of the
control source.
SYST START ACT This Object indicates the system
started status regardless of the
control source.
BYP FLT ACT This Object indicates the bypass
fault status.
SYS FLT ACT This Object indicates the system
fault status.
SYSTEM MODE This Object indicates if the
bypass or the drive is controlling
the motor.
WARNING ACT This Object indicates the bypass
warning status.
BYP RUN ACT This Object indicates the bypass
run status regardless of the
control source.
READY TO RUN This Object indicates whether
the system is ready to receive a
run command.
UNDERLOAD This Object indicates whether
the system is in an underload
condition.
ENABLE ACT This Object indicates the System
Enable command status (the
combination of all Run and Start
Interlocks), regardless of the
control source.
Description
ON/OFF
(also requires
COMM
ON/OFF
(also requires
COMM
Description
Inactive Text
RUN/STOP
START/NO
START
FAULT/OK
FAULT/OK
BYPASS/
DRIVE
WARNING/OK R
RUN/STOP
READY/NO
READY
YES/NO
ENABLE/
DISABLE
Active/ Present Value
Inactive Text Access Type
C
C
Active/ Present Value
Access Type
R
R
R
R
R
R
R
R
R
Embedded fieldbus
135