ABB ACH580 Series User Manual page 159

150
Bit
29
30
Status Word
The contents of the
master station.
ABB drives profile
The following table and the state diagram later in this sub-section describe the status
word content for the ABB Drives Profile.
Bit
0
1
2
3
4
5
6
7
8
9
Embedded fieldbus
ACH580 E-Clipse bypass and packaged drive user manual
DCU Profile CONTROL WORD
Name Value
LINK_ON 1
0
REQ_STARTINH 1
0
STATUS WORD
ABB Drives Profile (EFB) STATUS WORD
Name
RDY_ON 1
0
RDY_RUN 1
0
RDY_REF 1
0
TRIPPED 0...1
0
OFF_2_STA 1
0
OFF_3_STA 1
0
SWC_ON_INHIB 1
0
WARNING 1
0
AT_SETPOINT 1
0
REMOTE 1
0
Function
Master is detected
in link
Link is down
Start inhibit request
is pending
Start inhibit request
is OFF
is status information, sent by the drive to the
Value
(Correspond to states/boxes in the state diagram)
READY TO SWITCH ON
NOT READY TO SWITCH ON
READY TO OPERATE
OFF1 ACTIVE
OPERATION ENABLED
OPERATION INHIBITED
FAULT
No fault
OFF2 INACTIVE
OFF2 ACTIVE
OFF3 INACTIVE
OFF3 ACTIVE
SWITCH-ON INHIBIT ACTIVE
SWITCH-ON INHIBIT NOT ACTIVE
Warning/warning (See
section for details on warnings.)
No warning/warning
. Actual value equals (within tolerance limits)
OPERATING
the reference value.
Actual value is outside tolerance limits (not equal to
reference value).
Drive control location:
Drive control location: LOCAL
Comments
Description
Warning listing in the Diagnostics
(EXT1 or EXT2)
REMOTE