ABB ACH580 Series User Manual page 206

ACH580 E-Clipse bypass and packaged drive user manual
Error messages
#
1
2
3
4
5
6
7
8
9
10
Error Message
CAN'T EDIT
PAR IS READ ONLY
CAN'T EDIT
WHEN STARTED
CAN'T EDIT
UP+DOWN ONLY
CAN'T EDIT
INP VOLTAGE LOW
CAN'T EDIT
PAR IS HIDDEN
CAN'T EDIT
UNDER LO-LIMIT
CAN'T EDIT
UNDER HI-LIMIT
CAN'T EDIT
ENUM VAL ONLY
CAN'T EDIT
NO DEFAULT
CAN'T EDIT
TRY AGAIN.
Description
Try to save value (=press the ENTER key in Parameter Edit
State) of a read-only parameter. E.g. try to change value PAR
01.02 INPUT VOLT
Try to change value of a parameter, which is allowed to be
changed only when system is not started. E.g. PAR 16.02
RUN PERMISSIVE
Try to change value of a "reset only" parameter other than
zero. UP+DOWN buttons must be pressed simultaneously
for requesting default value of the PAR on the display (value
zero), and after that ENTER pressed for saving it (reset the
parameter). E.g. PAR 04.01 LAST FAULT
Input voltage too low. Changing of parameters prohibited
since system cannot save values to nv-mem w/ insufficient
voltage.
Try to save value (=press the ENTER key in Parameter Edit
State) of a hidden parameter. Should not be possible. If
hidden parameters are turned visible, this message is not
given.
Try to save value which is over LO-LIMIT of the parameter.
Should not be possible when changing parameters from
control panel.
Try to save value which is over HI-LIMIT of the parameter.
Should not be possible when changing parameters from
control panel.
Try to save value which is out of enumerated value list.
Should not be possible when changing parameters from
control panel.
Try to request default value (=press UP and DOWN buttons
simultaneously) for a parameter which is defined not to have
a default value. Should not be possible when changing
parameters from control panel.
Parameter system is busy, e.g. application macro change is
in process at the same time when someone is trying to save
a value for a parameter. Should not be possible when
changing parameters from control panel.
197
Diagnostics