ABB ACH580 Series User Manual page 185

176
Bit
2
3
4
5
6
7
8...9
10
11
12...15 Unused
Fieldbus adapter
ACH580 E-Clipse bypass and packaged drive user manual
ABB Drives Profile (FBA) CONTROL WORD
Name Value
OFF3 1
CONTROL
0
INHIBIT 1
OPERATION
0
RAMP_OUT_ 1
ZERO
0
RAMP_HOLD 1
0
RAMP_IN_ 1
ZERO
0
RESET 0=>1
0
Unused
REMOTE_CMD 1
0
EXT CTRL LOC 1
0
Commanded
State
OPERATING Continue operation (OFF3 inactive)
EMERGENCY Drive stops within in time specified by
STOP parameter 2208.
Normal command sequence:
• Enter OFF3 ACTIVE
• Proceed to SWITCH ON INHIBITED
WARNING! Be sure motor and driven
equipment can be stopped using this
mode.
OPERATION Enter OPERATION ENABLED (Note the
ENABLED Run Permissive signal must be active.
See 1601. If 1601 is set to COMM, this bit
also actives the Run Permissive signal.)
OPERATION Inhibit operation. Enter OPERATION
INHIBITED INHIBITED
NORMAL Enter RAMP FUNCTION GENERATOR:
OPERATION ACCELERATION ENABLED
RFG OUT ZERO Force ramp function generator output to
Zero. Drive ramps to stop (current and DC
voltage limits in force).
RFG OUT Enable ramp function.
ENABLED
Enter RAMP FUNCTION GENERATOR:
ACCELERATOR ENABLED
RFG OUT HOLD Halt ramping (Ramp Function Generator
output held)
RFG INPUT Normal operation. Enter OPERATING
ENABLED
RFG INPUT ZERO Force Ramp Function Generator input to
zero.
RESET Fault reset if an active fault exists (Enter
SWITCH-ON INHIBITED). Effective if
1604 = COMM.
OPERATING Continue normal operation
Fieldbus control enabled
• CW
Ref.
• CW = 0 and Ref = 0: Fieldbus control
enabled.
• Ref and deceleration/acceleration ramp
are locked.
EXT2 SELECT Select external control location 2 (EXT2).
Effective if 1102 = COMM.
EXT1 SELECT Select external control location 1 (EXT1).
Effective if 1102 = COMM.
Comments
= / = /
0 or Ref 0: Retain last CW and