Session Startup - Analog Devices ADSP-BF526 EZ-Board Manual

VisualDSP++ Install and Session Startup
To connect the EZ-Board to a PC via a standalone debug agent:

The debug agent can be used only when power is supplied from the
wall adaptor.
1. Attach the standalone debug agent to connectors
and
ZP1
pin of
P1
(labeled
P14
2. Plug one side of the provided USB cable into the USB connector
( ) of the standalone debug agent. Plug the other side of the
ZP1
cable into a USB port of the PC running VisualDSP++.
The other USB connector on the ADSP-BF526 EZ-Board (labelled
USB OTG
3. Verify that the yellow USB monitor LED on the standalone debug
agent (
LED4
that the board is communicating properly with the host PC and
ready to run VisualDSP++.

Session Startup

1. If you are running VisualDSP++ for the first time, navigate to the
VisualDSP++ environment via the Start > Programs menu. The
main window appears. Note that VisualDSP++ is not connected to
any session. Skip the rest of this step to step 2.
If you have run VisualDSP++ previously, the last opened session
appears on the screen. You can override the default behavior and
force VisualDSP++ to start a new session by pressing and holding
down the Ctrl key while starting VisualDSP++. Do not release the
Ctrl key until the Session Wizard appears on the screen. Go to
step 3.
1-10
on the backside of the EZ-Board, watching for the keying
to connect correctly. Plug the 5V adaptor into connector
).
5.0V
, ) is for applications use.
P8
, located near the USB connector) is lit. This signifies
ADSP-BF526 EZ-Board Evaluation System Manual
(labeled )
P1 JTAG