Ez-Board Session Startup - Analog Devices EZ-Board ADSP-BF518F Manual

EZ-Board Session Startup

To connect the EZ-Board to a PC via an emulator:
1. Plug the 5V adaptor into connector
2. Attach the emulator header to connector
back side of the EZ-Board.
To connect the EZ-Board to a PC via a standalone debug agent:
The debug agent can be used only when power is supplied from the
wall adaptor.
1. Attach the standalone debug agent to connectors
and
ZP1
pin of
P1
(labeled
J3
2. Plug one side of the provided USB cable into the USB connector of
the standalone debug agent. Plug the other side of the cable into a
USB port of the PC running VisualDSP++ 5.0 update 5 or later.
3. Verify that the yellow USB monitor LED on the standalone debug
agent (
LED4
fies that the board is communicating properly with the host PC
and ready to run VisualDSP++.
EZ-Board Session Startup
1. If you are running VisualDSP++ for the first time, navigate to the
VisualDSP++ environment via the Start–>Programs menu. The
main window appears. Note that VisualDSP++ is not connected to
any session. Skip the rest of this step to step 2.
If you have run VisualDSP++ previously, the last opened session
appears on the screen. You can override the default behavior and
force VisualDSP++ to start a new session by pressing and holding
1-6
on the backside of the EZ-Board, watching for the keying
to connect correctly. Plug the 5V adaptor into connector
).
5V
, located on the back side of the board) is lit. This signi-
ADSP-BF518F EZ-Board Evaluation System Manual
(labeled ).
J3 5V
(labeled
P1 JTAG
(labeled
P1
) on the
)
JTAG