Analog Devices ADSP-BF526 EZ-Board Manual page 56

Power Setup
Table 1-5. 5V Power Settings (Cont'd)
Switch/Jumper
P23
P25
SW22
To set up the board for battery operation, the settings in
good starting point.
Table 1-6. Battery Power Settings
Switch/Jumper
JP8
(if 5V needed on the expansion interface II)
JP9
(if 5V needed on expansion interface II)
JP10
JP15
P17
P23
P25
SW22
Refer to the individual switch and jumper descriptions for alternate
settings.

Note that complying with USB current limitations requires limit-
ing the charging rate and implementation of power saving features.
1-34
5V Setting
OFF
OFF
OFF
Battery Setting
Positions 5 and 6, 7 and 8
Uninstalled
Positions 1 and 2
See
See
OFF
ON
ON
ADSP-BF526 EZ-Board Evaluation System Manual
Table 1-6
Table 1-4
Table 1-4
; see Table 1-4
are a