Configuration With The “Ea-Config.xml” File - WAGO 750 Series Manual

Configuration with the "EA-config.xml" file
Note
If you wish to directly assign the module mapping using the EA-config.xml
file stored in the controller, you must not have previously stored any
configuration settings in WAGO-I/O PRO, since this file will be overwritten
by the entries in WAGO-I/O-PRO on performing a download
1. Open the FTP client you wish to use (e.g., "LeechFTP", which is freely
2. To access the file system of the controller, enter the IP address of the
3. Copy the file into a local directory on your PC and open it with a text editor
4. The fourth line contains the necessary information for the first module. The
5. Now add under the fourth line the same syntax for each individual module
Note
The number of line entries must agree with the number of hardware modules
present in your node.
6. Save the file and download it back to the file system of the controller using
7. You can now start programming with WAGO-I/O-PRO CAA.
More information
For a detailed description on how to use the software, please refer to the
WAGO-I/O-PRO CAA manual. An electronic copy of this manual can be
found on WAGO's web site:
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
downloadable on the Internet).
controller in the FTP client. Also, set the user name to admin and the
password to wago. The "EA-config.xml" file can be found in the folder etc.
on the PFC server.
(e.g., "NotePad"). The following syntax is already prepared in the file:
entry [MAP="PLC"] assigns control rights to the IEC 61131-3 program for
the first module. If you want to change the control setting, replace "PLC"
with "FB1" for control rights from MODBUS TCP, or with "FB2" for
control from Ethernet IP.
with the appropriate control assignment:
<Module ITEM NO.="" MAP="(e.g.) PLC" LOC="ALL"></Module>.
the FTP client.
Fieldbus Controller 750-841
Programming the PFC with WAGO-I/O-PRO CAA
www.wago.com
• 93