Testing The Function Of The Fieldbus Node - WAGO 750 Series Manual

82 • Fieldbus Controller 750-841
Starting up an ETHERNET TCP/IP fieldbus node
Note
You can download a free copy of the WAGO Ethernet Settings" which you
can find on the „ELECTRONICC Tools and Docs" CD ROM (Item-No.:
0888-0412-0001-0101) and on the WAGO Web pages under
www.wago.com, "Service
For a short description to this you can find the "Quick Start" for the
ETHERNET Fieldbus Controller 750-841. Please have a look on the WAGO
Web pages under www.wago.com, "Service
Documentation".
1. Start the programm "WAGO Ethernet Settings".
2. Chose the register "TCP/IP".
3. In order to give the address now, change the specified option for the
4. Enter the desired IP address and if necessary the address for the Subnet
5. Click on the button "Write", to write the address down on the controller.

3.1.7.1.3 Testing the Function of the Fieldbus Node

1. To test the controller's newly assigned I/P address, start a DOS window by
2. In the DOS window, enter the command: "ping " followed by the PFC's IP
Fig. 3-11: Example for the Function test of a Fieldbus Node
3. When the Enter key has been pressed, your PC will receive a query from
4. When the test has been performed successfully, you can close the DOS
5. Since the IP address is still temporarily stored in the controller. Do not
address assignment.
By default, the address is assigned automaticly with the BootP Server.
Activate now the option "Using following address" by clicking on the
radio button before this option.
Mask and for the Gateway.
clicking on the Start menu item Programs/MS-DOS Prompt
address in the following format:
ping [space] XXX . XXX . XXX . XXX (=IP address).
Example: ping 10.1.254.202
the controller, which will then be displayed in the DOS window.
If the error message: "Timeout" appears, please compare your entries
again to the allocated IP address and check all connections. Verify that the
TXD/RXD LEDs flash when the ping command is issued.
prompt.
cycle power on the controller until the BootP protocol has been disabled in
the PFC.
Downloads Software".
Downloads
P012910d
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP