System Supply; System Voltage - WAGO 750 Series Manual

20 •
The WAGO-I/O-SYSTEM 750
Power Supply

2.7.2 System Supply

2.7.2.1 Connection
The WAGO-I/O-SYSTEM 750 requires a 24 V direct current system supply
(-15% or +20 %). The power supply is provided via the coupler / controller
and, if necessary, in addition via the internal system supply modules
(750-613). The voltage supply is reverse voltage protected.
Attention
The use of an incorrect supply voltage or frequency can cause severe damage
to the component.
Fig. 2-11: System Supply
The direct current supplies all internal system components, e.g.
coupler/controller electronics, fieldbus interface and bus modules via the
internal bus (5 V system voltage). The 5 V system voltage is electrically
connected to the 24 V system supply.
Fig. 2-12: System Voltage
g0xxx02e
g0xxx06e
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP