Storage, Assembly And Transport; Mechanical Setup; Total Expansion - WAGO 750 Series Manual

2.5 Storage, Assembly and Transport

Wherever possible, the components are to be stored in their original
packaging. Likewise, the original packaging provides optimal protection
during transport.
When assembling or repacking the components, the contacts must not be
soiled or damaged. The components must be stored and transported in
appropriate containers/packaging. Thereby, the ESD information is to be
regarded.
Statically shielded transport bags with metal coatings are to be used for the
transport of open components for which soiling with amine, amide and
silicone has been ruled out, e.g. 3M 1900E.

2.6 Mechanical Setup

2.6.1 Installation Position
Along with horizontal and vertical installation, all other installation positions
are allowed.
Attention
In the case of vertical assembly, an end stop has to be mounted as an
additional safeguard against slipping.
WAGO item 249-116
WAGO item 249-117

2.6.2 Total Expansion

The maximum total expansion of a node is calculated as follows:
Quantity
1
64
1
sum
Warning
The maximal total expansion of a node must not exceed 831 mm
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
End stop for DIN 35 rail, 6 mm wide
End stop for DIN 35 rail, 10 mm wide
Width Components
51 mm coupler / controller
12 mm bus modules
- inputs / outputs
- power supply modules
- etc.
12 mm end module
831 mm
The WAGO-I/O-SYSTEM 750
Storage, Assembly and Transport
• 11