Before You Run The Ecu - Digital Equipment 3300R Service Manual

Before You Run the ECU

Before running the ECU:
1. Install EISA option(s). (Install ISA boards after you run the ECU.)
For information about installing a specific option, refer to the documentation for that
option.
2. Familiarize yourself with the utility.
You can find more information about the ECU by reading the ECU online help. Start
the ECU. (Refer to the next section.) Online help for the ECU is located under Step 1,
"Important EISA Configuration Information."
3. Familiarize yourself with the configuration procedure for the system:
•
If you are configuring an EISA bus that contains only EISA options, refer to
Table 6-2.
•
If you are configuring an EISA bus that contains both ISA and EISA options,
refer to Table 6-3.
4. Locate the ECU diskette. The ECU diskette is shipped in the accessories box with the
system. Make a copy of the diskette, and keep the original in a safe place. Use the
backup copy for configuring options. The diskette is labeled as follows:
•
ECU Diskette DECpc AXP (AK-PYCJ*-CA) for Windows NT
System Configuration and Setup
DIGITAL Server 3300/3300R 6–19