Verifying Configuration: Srm Console Commands; Show Config - Digital Equipment 3300R Service Manual

Verifying Configuration: SRM Console Commands

You can also list options recognized by your system by entering the commands listed
below. The following SRM console commands are used to verify system configuration.
NOTE: To enter these commands, you must switch from the AlphaBIOS console to the
SRM console.
•
show config—Displays the buses on the system and the devices found on those buses.
•
show device—Displays the console bootable devices and controllers in the system.
•
show memory—Displays main memory configuration.
•
set and show—Set and display environment variable settings.

show config

The show config command displays all devices found on the system, including PCI and
EISA bus devices. You can use the information in the display to identify target devices for
commands such as boot and test, as well as to verify that the system sees all the installed
devices.
System Configuration and Setup
DIGITAL Server 3300/3300R 6–5