Set Dial; Set Escape; Set Init - Digital Equipment 3300R Service Manual

Server Management Console

set dial

The set dial command sets the dial string to be used when the RMC detects an alert
condition. Note that this string must be in the correct dial string format for the attached
modem. If a paging service is to be contacted, then the dial string must include the
appropriate modem commands to dial the number, wait for the line to connect, and send
the appropriate touch tones to leave a pager message. The dial string is limited to 31
characters.
Example:
RCM> set dial
dial> ATXDT15085551234
RCM>

set escape

The set escape command allows the user to change the escape sequence used for exiting
pass-through mode and entering console monitor mode. The escape sequence can be any
character string. A typical sequence consists of two or more control characters for a
maximum of 14 characters. It is recommended that control characters be used in
preference of ASCII characters.
Example:
RCM> set escape
new esc> ^[^[rmc
RCM>

set init

The set init command sets the modem initialization string. This string is limited to 31
characters and may be modified depending on the type of modem used. Some typical
initialization strings are:
Modem
Motorola 3400 Lifestyle 28.8
AT &T Dataport 14.4/FAX
Hayes Smartmodem Optima 288
V-34/V.FC + FAX
4–16 DIGITAL Server 3300/3300R
Initialization String
at&f0e0v0x0s0=2
at&f0e0v0x0s0=2
at&fe0v0x0s0=2