Srm Interface; Alphabios Menu Interface - Digital Equipment 3300R Service Manual

SRM Interface

The SRM console allows you to configure and test the system, examine and alter system
state, and boot the operating system.
The SRM console prompt is >>>.
Several system management tasks can be performed only from the SRM console:
•
All console test and reporting commands are run from the SRM console.
•
Certain environment variables are changed using the SRM set command. For
example:
ew*0_mode
ew*0_protocols
pk*0_fast
pk*0_host_id
To run the ECU, you can enter the ecu command to load the AlphaBIOS firmware and
boot the ECU from diskette. You can also load AlphaBIOS firmware using the alphabios
command.

AlphaBIOS Menu Interface

You use the AlphaBIOS menus to configure and boot the system, to run the EISA
Configuration Utility (ECU), to run the RAID Configuration Utility (RCU) and adapter
configuration utility, or to set environment variables.
•
You must run the EISA Configuration Utility (ECU) whenever you add, remove, or
move an EISA or ISA option in your
diskette. For more information about running the ECU, see the section "EISA
Configuration Utility" later in this chapter.
•
If you have a StorageWorks RAID array subsystem, you must run the RAID
Configuration Utility (RCU) to set up the disk drives and logical units. See the
documentation included in your RAID kit.
System Configuration and Setup
Server system. The ECU is run from
DIGITAL
DIGITAL Server 3300/3300R 6–3