Halt Out; Hangup; Help Or - Digital Equipment 3300R Service Manual

Server Management Console

halt out

The halt out command is the equivalent of setting the Halt button on the server front panel
to the "out" position. After executing the halt out command, the user is switched from the
RMC monitor to the server's COM1 port. Note that a local operator physically placing the
front panel Halt button to the "in" position takes precedence over the setting of this
command.
Example:
RCM> halt out
Returning to COM port.

hangup

The hangup command terminates the modem session. Once issued, the user will no
longer be connected to the server.
Example:
RCM> hangup
RCM>

help or ?

The help or ? command displays the command set.
Example:
RCM> help
clear {alert, port}
disable {alert, reboot, remote}
enable {alert, reboot, remote}
halt {in, out}
hangup
help or ?
power {off, on}
quit
reset
send alert
set {alert, baud, dial, escape, init, password, wdt}
status
4–12 DIGITAL Server 3300/3300R