How To Run The Ecu - Digital Equipment 3300R Service Manual

System Configuration and Setup

How to Run the ECU

Complete the following steps to run the ECU:
1. Invoke the AlphaBIOS console firmware—Shut down the operating system or power
up to the AlphaBIOS Setup menu. (Refer to the
Guide for more information on the AlphaBIOS console.)
2. To start the ECU, select from the following menus:
NOTE: Make sure the ECU diskette is not write-protected.
a. From the AlphaBIOS Setup menu, select Utilities.
b. From the submenu, select Run Maintenance Program. Insert the ECU diskette
into the diskette drive and select Run ECU from floppy.
3. Complete the ECU procedure according to the guidelines provided in the following
sections.
•
If you are configuring an EISA bus that contains only EISA options, refer to
Table 6-2.
NOTE: If you are configuring only EISA options, do not perform Step 2 of the ECU, "Add
or remove boards." (EISA boards are recognized and configured automatically.)
•
If you are configuring an EISA bus that contains both ISA and EISA options,
refer to Table 6-4.
4. After you have saved configuration information and exited from the ECU, remove the
ECU diskette from the diskette drive and boot the operating system.
5. Verify that the new options are configured correctly.
6–20 DIGITAL Server 3300/3300R
Server 3300/3300R User's
DIGITAL