Hard Disk Drives; Figure 7-16 Removing Hard Disk Drives - Digital Equipment 3300R Service Manual

Hard Disk Drives

NOTE: If the drives are plugged into a RAID controller, you can "hot swap" drives; that is,
you can add or replace drives without first shutting down the operating system or
powering down the server hardware. (See the StorageWorks RAID Array Subsystem
Family Installation and Configuration Guide.)
If the drives are not plugged into a RAID controller, you will need to shut down the
operating system before swapping a drive. However, you will not need to power
down the server before installing the drives.

Figure 7-16 Removing Hard Disk Drives

WARNING: When removing the right-most drive (or top-most for rackmount
systems, remove the disk drive door to avoid the possibility of
hitting your hand against the door.
FRU Removal and Replacement
IP00040A
DIGITAL Server 3300/3300R 7–23