Table of Contents
Advertisement
Chapter 2
Using the System
This chapter describes how to use your system once the system software has
been installed.
2.1 Before You Use a New System
This chapter assumes that your system has been properly installed by a
DIGITAL service representative. Installation includes running the diagnostic
software shipped with your system. To install operating system options or
layered products, see the instructions in your system software installation
manual or layered product installation manual. Some of the instructions may
require you to open the front door of the system to change switch settings.
The remainder of this chapter assumes that system software has been installed.
2.2 Switch Settings
Switch settings vary, depending on the operation being performed. The next
two sections describe switch settings for normal and for special operations.
Set the switches according to your needs.
2.2.1 Normal Operation
Switch settings for normal operation are the following:
•
The Halt button on the mass storage control panel is set to out.
•
The Break Enable/Disable switch on the CPU cover panel is set to disable
(down position). With break disabled, your system automatically boots
system software when powered up. Once system software is installed,
DIGITAL recommends you run your system with breaks disabled to
prevent the user of the console terminal from inadvertently halting the
system by pressing
Break
on the console terminal. Halting the system
causes all activity to stop.
•
The Power-Up Mode switch on the CPU cover panel is set to Run
(indicated by an arrow).
Using the System 2-1
Advertisement
Table of Contents
