System Configuration - YASKAWA YRC1000 Instructions Manual

2 Setup
2.5

System Configuration

2.5 System Configuration
The following figure illustrates the configuration procedure outline. The
following and later pages explain the detailed procedure of each setting.
Note that the initialization processing after system upgrade is omitted.
Language, model, I/O module, ...
Initialization processing of each items
For Fronius welding power source,
change the "ARC WELDING" setting
from "STANDARD" to "ENHANCED"
[2.5.2] Setting of Optional Function
[2.5.3] Setting of Optional Function
[2.5.5] I/O Module Setting Check
after Adding Virtual EW Module
* When the welder is FroniusTPSi;
[2.5.6] Setting of Optional
Function "MotoPlus Function"
[2.5.7] Loading of Dedicated
MotoPlus Application
[2.5.8] Setting of Parameter
Start
Did you upgrade
system software?
Y E S
[Initialization] entry
:
[SETUP] entry
"Network Function"
"WELDCOM Function"
[2.5.4] Detailed Setting of
Welding Power Source
End
2-5
HW1484216
N O
[SETUP] entry
[2.5.1] I/O Module Setting Check
after Changing EW Board
Station Number Setting
HW1484216
16/79