Setting Of Parameter (When Welder Is Froniustpsi) - YASKAWA YRC1000 Instructions Manual

2.5.10 Setting of Parameter (When Welder is FroniusTPSi)

2 Setup
2.5 System Configuration
The settings described in chapter 2.5.4 "Detailed Setting of Welding
Power Source" can also be used for normal startup.
Set the parameter by following the procedure below.
Select {SYSTEM} → {SECURITY} → "MANAGEMENT MODE".
– A password must be entered after selecting "MANAGEMENT MODE".
1. Select {ARC WELDING} → {APPLICATION CONDITION SETTING}.
2. To see the welding currents and voltages obtained and the error codes
in the concurrent IO ladder, specify the M register address of output
destination accordingly.
For details of each item, refer to the following table.
– Selecting {APPLICATION CONDITION SETTING} displays the
following window.
– {APPLICATION CONDITION SETTING} window varies depending
on a welding power source type.
<FroniusTPSi type>
2-21
HW1484216
HW1484216
32/79