YASKAWA YRC1000 Instructions Manual page 52

4 Job Preparation for Welding
4.1 Job Preparation for Welding
4. When using a FroniusTPSi-type welding power source, edit the
welding condition file so that the conditions are specified by using the
following physical quantity, not by welding current instruction or
welding voltage instruction.
• V1: Wire feeding speed (m/min)
The range varies depending on the welding type.
• V2: Arc Length
Set the value between -10.0% and +10.0%.
• V3: Pulse/Dynamic
Set the value between -10.0% and +10.0%.
• V4: Wire retraction
Set the value between 0.00 and 10.00.
V2: Arc Length
Controls the arc length.
+: Long arc-length, -: Short arc-length
V3: Pulse/Dynamic
For details, see the user manual of the welding power source.
V4: Wire retraction
For details, see the user manual of the welding power source.
4-3
HW1484216
HW1484216
52/79