Froniustpsi Type: Operation Of Top Window - YASKAWA YRC1000 Instructions Manual

HW1484216
3.11
3 Operation of Welding Condition File Edit Window

3.11 FroniusTPSi Type: Operation of Top Window

FroniusTPSi Type: Operation of Top Window
1. Display {OTHER} tab of the welding condition file, and then press
{Welder setting}.
– When the welding type database is not obtained yet, obtain the
database from the welder.
Open the Weld Parameter Setting window.
(When using Job mode of Fronius power source, put a check mark
in the check box of Job mode.)
2. Select a weld user file.
{Type:ISO/AWS}: Switches the display of materials.
{Unit:mm/inch}: Switches the unit of wire diameter.
{Refresh DataBase}:
Obtains the welding type database from the welder again.
3. Select {Select Synergic}.
– The welding type can be set to the selected weld user file.
→ Go to Select Synergic window.
4. Select {Set Parameter}.
– The parameter setting of the selected weld user file can be changed.
→ Go to Weld Parameter Setting window.
3-12
HW1484216
47/79