Setting Of Optional Function "Network Function - YASKAWA YRC1000 Instructions Manual

2.5.2 Setting of Optional Function "Network Function"

2 Setup
2.5 System Configuration
The WELDCOM function uses the network function (optional function).
Set the network function by following the procedure below.
1. Select {SYSTEM} → {SETUP} → "OPTION FUNCTION", and then
"DETAIL" of "LAN INTERFACE SETTING".
2. Change the setting of "DEVICE" from "NOT USED" to "MANUAL
SETTING".
– Set the Network (Ethernet) function to enable.
3. After setting "IP ADDRESS SETTING" to "MANUAL SETTING",
change "IP ADDRESS" to "192.168.255.200".
• Set "SUBNET MASK" to "255.255.255.0".
2-7
HW1484216
HW1484216
18/79