Functional Overview; Overview - YASKAWA YRC1000 Instructions Manual

1

Functional Overview

1.1
1 Functional Overview
1.1

Overview

Overview
The WELDCOM function serves as a digital interface that communicates
via Ethernet with an arc welding power source. The function provides high
data rate transmission between YRC1000 and the welding power source,
enables the welding power source parameter to be set from the
programming pendant, and monitors graphically welding current and
voltage during welding.
 The WELDCOM function can use either of the following four welding
power sources for connection.
MOTOWELD-EL350-AJ2E (manufactured by YASKAWA
1
ELECTRIC CORPORATION)
(AJ2E indicates that an Ethernet interface is incorporated.)
MOTOWELD-RP500 (manufactured by YASKAWA ELECTRIC
2
CORPORATION)
(In the case of digital communication mode)
MOTOWELD-RL350 (manufactured by YASKAWA ELECTRIC
3
CORPORATION)
(In the case of digital communication mode)
MOTOWELD-X350 (manufactured by YASKAWA ELECTRIC
4
CORPORATION)
MOTOWELD-X500 (manufactured by YASKAWA ELECTRIC
5
CORPORATION)
MOTOWELD-RD350S/S-AC (manufactured by YASKAWA
6
ELECTRIC CORPORATION)
7 MOTOWELD-RD500S (manufactured by YASKAWA ELECTRIC
CORPORATION)
( , ,
7
5 6
8 TPS4000 CMT (manufactured by Fronius International GMBH)
(Only the model that incorporates the WeldCom interface)
TPSi (manufactured by Fronius International GMBH)
9
(System version: YAS1.34.00(□)-00 or later)
(Only the model that incorporates the WeldCom interface)
 Programming a job is available using general arc welding
commands.
ARCSET ASF#( ),
ARCON ASF#( ),
ARCOF AEF#( )
 Welding conditions are set in a welding start condition file or a
welding end condition file specified in an arc welding command.
 The welding start condition file or welding end condition file has the
edit window that provides the setting window for a digital interface,
enabling users to check or edit parameters to be set in welding
power source.
 The parameter to be set in the edit window of the welding condition
file is saved in the dedicated condition file, "Welding type file" and
"Digital welder condition file", where the data can be loaded and
saved with the external memory function.
System version: YAS2.03.00(□)-00 or later)
1-1
HW1484216
HW1484216
10/79