YASKAWA YRC1000 Instructions Manual page 29

HW1484216
Item
POWER SOURCE IP
ADDRESS
VOLT.CMD.:REGIST.ADDR.
CURR.CMD.:REGIST.ADDR.
SAMPLING
VOLT.:REGIST.ADDR.
SAMPLING.
CURR.:REGIST.ADDR.
SAMPLING W.F.S.:
REGIST.ADDR.
FEEDER MTR.
CURR.:REGIST.ADDR.
SHORT-CIRCUIT
CNT.:REGIST.ADDR.
ERROR
CODE:REGIST.ADDR.
WELDER USER
FILE#:REGIST.ADDR.
2 Setup
2.5 System Configuration
Contents
Sets the IP address of the welding power source.
E.g.) When the IP address is 192.168.255.211
AxP76=192, AxP77=168, AxP78=255, AxP79=211
Sets the welding voltage command output register
address.
The values that can be set in the register address are
as follows.
-1: Processing is invalid.
0 - 399: General register number
The unit of the voltage command to be output is 0.1 V.
Sets the welding current command output register
address.
The values that can be set in the register address are
as follows.
-1: Processing is invalid.
0 - 399: General register number
The unit of the current command to be output is 0.1 A.
Sets the register address for the sampling welding
voltage value.
Sets the register address for the sampling welding
current value.
Sets the register address for the sampling welding
feeder speed value output.
Sets the register address for the sampling welding
feeder load (feeding motor current) value output.
The unit of the feeder load to be output is 0.1 A.
Sets the register address for the welding short-circuit
count output.
Sets the error code input register address.
Sets the register address for the welding user file
number input.
2-18
Parameter Initial
AxP76
AxP77
AxP78
AxP79
AxP60
AxP61
AxP147
AxP148
AxP81
AxP82
AxP83
AxP85
AxP89
HW1484216
value
192
168
255
210
150
151
152
153
NO USE
NO USE
NO USE
NO USE
154
29/79