Detailed Setting Of Welding Power Source - YASKAWA YRC1000 Instructions Manual

2.5.4 Detailed Setting of Welding Power Source

2 Setup
2.5 System Configuration
After setting the digital interface in the WELDER SETUP window and
initializing the related files, "Type" shows VEW01, indicating that the
virtual EW module for the digital interface has been assigned. Perform
detailed setting for each welding power source by following the procedure
below.
Set the each welding power source by following the procedure below.
1. VEW01 (Virtual EW module) has been assigned. Move the cursor to
the "DETAIL" in the far right, and press the [SELECT] key.
– VEW01 for the digital interface has been assigned.
2. The WELDCOM function works with the default detailed settings. You
do not especially need to make settings. Press the [ENTER] key to
confirm the setting.
To see the welding currents and voltages obtained and the error codes
in the concurrent IO ladder, specify the M register address of output
destination accordingly.
• Selecting "DETAIL" displays the following DETAILED SETUP win-
dow.
• The DETAILED SETUP window varies depending on a welding
power source type.
<MOTOWELD type>
2-11
HW1484216
HW1484216
22/79