2.4
2.4.1 Standard Connection (When connecting one welding power source of digital interface to
YRC1000)
2
Setup
2.4
Connection of Welding Power Source and YRC1000
When applying digital interface to welder and using EW board as
general analog output board
Because the EW board is automatically set as welding application due
to the configuration restrictions, set the arc application to Arc + Arc.
Specifically, set as follows:
• Set the application setting of [Initialization] to "Arc + Arc", and set Arc
2 as not for use.
• In [OPTION FUNCTION - WELDCOM FUNC.], set Arc 1 to digital
interface.
Connection of Welding Power Source and YRC1000
• Connect a LAN cable to ACP01 for LAN (CN106).
•
Use the LAN cable that comes with our arc welding robot package
MOTOPAC. (The system may not properly work with a LAN cable
other than this, and we are not responsible for any problems that
may occur.)
When preparing a LAN cable other than the cable above
SUPPLE
• You can use either cross cable or straight cable.
-MENT
• Use a cable with the connector that has a metal cover for
noise suppression and with the cable shield grounded to
the metal cover.
CAUTION
2-3
HW1484216
HW1484216
14/79