Rear View - Ikegami HDL-45E Operation Manual

3 - 2 3. NAME and FUNCTION of EACH PART

3.2 Rear View

①
⑮
⑭
⑬
⑫
⑪
① FAN
② HD SDI OUT connector
③ COMMAND connector
④ MON OUT connector
⑤ EXT SYNC connector
① FAN
Fan makes heat sink for camera body.
② HD SDI OUT connector
Outputs the HD SDI signal (BNC 2ch).
(Conforms to SMPTE 292M)
③ COMMAND connector
Used to connect the camera and the remote control panel
(RCP-50B: optionally available) with the CP cable (RCC-
854 or RCC-274: optionally available) to remotely control
the camera (Max: 200m).
④ MON OUT connector
Outputs the video signal (G/B/R, Y/Pb/Pr) set by setting
menu of the camera or the remote control box.
Connect the external monitor with the specified cable.
⑤ EXT SYNC connector
Inputs the sync signal of an external system desired to be
genlocked with the equipment (internal termination 75 ).
⑥ G.L indicator
Lights up during the synchronizing the camera with the
SYNC signal of external system.
⑦ DC IN connector
Used to supply +12V(11-16V) DC power from the AC
pack.
Rear View (Standard)
⑥ G.L indicator
⑦ DC IN connector
⑧ AWB/ABB indicator
⑨ AWB/ABB select switch
⑩ MENU select switch
Do not input power as opposite polarity.
If so, the camera maybe damaged.
⑧ AWB/ABB indicator
Lights up during execution of AWB or ABB.
- AWB (Auto White Balance) execution : Lights up Green
- ABB (Auto Black Balance) execution : Lights up Orange
- Completion of AWB or ABB : Turn off automatically
- Incompletion / N.G of AWB : Green blinking
- Incompletion / N.G of ABB : Orange blinking
⑨ AWB/ABB select switch
Executes AWB or ABB.
AWB : White balance is adjusted automatically.
②
③
④
⑤
⑥
⑦
⑧
⑨
⑩
⑪ POWER switch
⑫ POWER indicator
⑬ GAIN select switch
⑭ CAM/BAR select switch
⑮ WARNING indicator
Pin
Name
Number
1
DC -
2
3
4
DC +
CAUTION
By setting this switch to AWB position, the
adjustment starts and the adjusted value is
stored in memory.