Table of Contents
Advertisement
ABB
: Black balance is adjusted automatically.
By setting this switch to ABB position, the
adjustment starts and the adjusted value is
stored in memory.
⑩ MENU select switch (Rotary Encoder)
Displays various information or control items on the
monitor to show the camera status by pressing and
holding this switch for more than one second.
Use this switch combined rotary encoder to set the
desired item with selection.
Notice
HD SDI outputs can be displayed on the MENU
screen through the setting of "SDI MENU MIX
(MENU PAGE5)" in "5.3 Camera Menu."
⑪ POWER switch
This is a switch for powering on the camera.
ON : The equipment is powered through out.
OFF : All the power is turned off.
⑫ POWER indicator
Lights up during turning the camera ON.
⑬ GAIN select switch
Changes the camera gain.
L, M, H: It becomes the gain set on the menu screen.
A set value can be arbitrarily selected from -6,
-3, 0, +3, +6, +9, +12, +18, +24, +30, +36,
+42, +48, +54dB and memorized in L, M, H.
But desired gain values should be set to satisfy
L < M < H.
⑭ CAM/BAR select switch
Use to select the video signal on the color bar signal.
CAM : Outputs the video signal.
BAR : Output the color bar signal
⑮ WARNING indicator
Lights up when the input voltage is low.
Blinks in red when a trouble occurs for the camera or
a fan.
For further details of troubles, refer to "WARNING
(MENU PAGE5)" in "5.3 Camera Menu."
Notice
• When the remote control panel is connected,
GAIN select switch and CAM/BAR select switch
cannot be controlled.
• When the camera menu "SYSTEM SELECT" is
set to ON in Engineering mode, the values
settings from the remote control panel have a
priority over the switch settings on the back of
the camera.
3. NAME and FUNCTION of EACH PART
3 - 3
Advertisement
Table of Contents
