Ikegami HDL-45E Operation Manual page 62

5 - 34 5. OPERATION
[ Hierarchical Structure of the Engineer Menus ]
MAIN MENU SUB MENU
NEXT PAGE -
SMOOTH KNEE SETUP QUIT
SMOOTH KNEE
TEST PULSE
POINT1
SLOPE1
POINT2
SLOPE2
POINT3
SLOPE3
LOAD INT
HI-LIGHT DTL SET UP QUIT
HI-LIGHT DTL
GAIN
LIMIT
ND FILE
AVC SETUP QUIT
FUNCTION
MODE
AVC DISPLAY
MODE
PRESET DAY FILE
DAY FILE CENTER
PRESET NIGHT FILE
DAY DETECT AREA
NIGHT DETECT AREA
GAIN LIMIT
D/N TIME
D/N CHANGE LEVEL
F LIMIT
F2.8
F VALUE
****** ENGINEER PAGE1
SELECT DEFAULT
- -
Moves to ENGINEER PAGE2.
- - Moves from the sub menu to the main menu.
OFF, TYPE1, TYPE2, TYPE3 TYPE1 Selects the SMOOTH KNEE type.
ON, OFF OFF
Turns on/off the test pulse for setting SMOOTH KNEE.
- - Sets the SMOOTH KNEE curve.
The entire curve can be determined by setting each one of the three
- - points of the curve.
Each curve of TYPE1, TYPE2, or TYPE3 can be set.
- -
- -
- -
- -
- - Initializes the data to the factory settings.
- - Moves from the sub menu to the main menu.
ON, OFF OFF
Turns on/off highlight DTL.
0 to +100 - Sets highlight DTL GAIN. Increasing the GAIN value
increases edges to be added to high luminance parts.
-100 to +100 - Sets the clip point of highlight DTL edge. Controls the amplitude of the
edge.
ON, OFF ON Offsets the color temperature for each ND filter when set to ON.
This corrects the white balance deviation which is caused by ND filter
incorporation. No offset is performed when set to OFF.
- -
Moves from the sub menu to the main menu.
ENABLE, DISABLE ENABLE Selects whether the operation of the AVC function is valid or invalid.
DISABLE is recommended for the indoor operation selection. ENABLE
is recommended for the outdoor operation selection.
QUIT
Moves to AVC SETUP menu.
ON, OFF OFF Performs the character display at the AVC operated condition to the
main line output.
Display items from the left: ND FILTER No., CC FILTER No., Iris F
value, operated condition, ("D"ay or "N"ight), gain display, AWB file
("A"ch/"B"ch/A"T"W coupled), NIGHT MODE output No., DAY MODE output No.
MODE1, 2, 3, 4, 5 MODE3 Selects the operation pattern of DAY mode.
MODE1, 2, 3, 4, 5 MODE3 Fixes the center position of the volume.
MODE1, 2, 3, 4, 5 MODE2
Selects the operation pattern of NIGHT mode.
AREA1, 2, 3, 4, 5, 6, 7 AREA4 Selects the photometry area of DAY mode.
AREA1, 2, 3, 4 AREA4 Selects the photometry area of NIGHT mode.
+12, +18, +24, +30, +18dB
Sets the limit value of NIGHT mode gain increase.
+36, +42, +48, +54dB
FAST, STANDARD STANDARD −
−
TYPE1, 2, 3, 4 TYPE1
QUIT Moves to AVC SETUP menu.
-40 to +70 The value of setting F value for entering NIGHT mode.
- F2.8 F value for entering NIGHT mode.
(1/2) ******
FUNCTION