Ikegami HDL-45E Operation Manual page 49

■ AUTO SETUP
QUIT
AWB WITH A.IRIS
AWB DETECT AREA
AWB MARKER
AWB REFERENCE
REFERENCE SET
AWB CC CONTROL
BLACK BALANCE
When the MENU select switch is pressed on the item to be set, the value on the right
blinks.
Keeping this state, turn the MENU select switch to select the desired value and press it.
[AWB WITH A.IRIS]
• ON: Forcibly controls the IRIS to perform AWB at 100% picture level.
• OFF: Performs AWB with the current IRIS value.
[AWB DETECT AREA]
• WIDE: Performs AWB using about 80% of the screen as the measurement area.
• SPOT: Performs AWB using about 10% (center) of the screen as the measurement area.
[AWB MARKER]
• ON: Displays a marker for the area measured for AWB.
• OFF: Does not display a marker for the measurement area.
[AWB REFERENCE]]
• ON: Performs AWB based on the value set for "REFERENCE SET."
• OFF: Performs AWB based on the picture level of G ch.
[REFERENCE SET]
Set the convergence values when AWB and ABB are performed.
When AWB and ABB are selected, "PUSH SET → START" blinks on the lower side of the menu screen. When the
MENU switch is pressed again at this time, AWB and ABB are performed. When you do not perform AWB and ABB, rotate
the MENU switch and move to another item.
• AWB
1. Set "AWB REFERENCE" to "ON."
2. Set the GAIN value for each channel.
3. Perform "REFERENCE SET."
4. Perform "AWB" to converge to the set value.
AUTO SETUP MODE
ON
WIDE
OFF
ON
ABB
ON
ABS+APS
• ABB
1. Set the PED value.
2. Perform "REFERENCE SET."
3. Perform "ABB" to converge to the set value.
5. OPERATION
(OFF, ON)
(WIDE, SPOT)
(OFF, ON)
(OFF, ON)
(ABB, AWB)
(OFF, ON)
(ABS, APS, ABS+APS)
5 - 21