Ikegami HDL-45E Operation Manual page 74

5 - 46 5. OPERATION
How to Change the Scanning Format
The scanning format of ENGINEER PAGE4 can be changed according to the following procedure.
● When doing it from the remote controller
1. Open the camera menu by the remote controller.
2. Keep selecting the NEXT PAGE and open the MENU PAGE5.
3. Select the item of REMOTE ENG MENU of the MENU PAGE5 and switches from OFF to ON.
When the REMOTE ENG MENU is turned on, the engineer menu comes to be opened.
4. Keep selecting the NEXT_PAGE and open the ENGINEER PAGE4.
5. Select the SCAN FORMAT SELECT of the ENGINEER PAGE4 and open the SCAN MODE of the submenu.
6. Select the scanning format with the SCAN MODE.
The following displays correspond to each format.
Display
1080I59.
1080I50
1080P23.SF
1080P24SF
1080P25SF
1080P29.SF
7. When the scanning format is selected, PUSH SET → START is displayed. And when it is selected again, the camera restarts
and the scanning format is switched. For cancelling, please return to QUIT.
Notice
Notice
● When doing it from the CCU MENU switch
1. Set the CAM/BAR switch to BAR, and press and hold the MENU switch until the WARNING lamp lights up.
By this operation, the engineer menu comes to be opened.
2. Select the NEXT_PAGE and open the ENGINEER PAGE4.
3. Select the SCAN FORMAT SELECT of the ENGINEER PAGE4 and open the SCAN MODE of the submenu.
4. Select the scanning format with the SCAN MODE.
The following displays correspond to each format.
Display
1080I59.
1080I50
1080P23.SF
1080P24SF
1080P25SF
1080P29.SF
5. When the scanning format is selected, PUSH SET → START is displayed. And when pressing the switch again, the camera
restarts and the scanning format is switched. For cancelling, please return to QUIT.
Notice
1080/59.94i
1080/50i
1080/23.98psF (Only for HDL-45E1.)
1080/24psF (Only for HDL-45E1.)
1080/25psF
1080/29.97psF
Once the menu is closed, the REMOTE ENG MENU of the MENU
PAGE5 is automatically turned off.
When selecting the scanning format again, please perform the
operation 1 - 3 again, and after the REMOTE ENG MENU is
turned on, perform the operation 4 - 7.
R e g a r d i n g h o w t o o p e r a t e t h e c a m e r a m e n u f r o m t h e r e m o t e
controller, please refer to the manual of each remote controller.
1080/59.94i
1080/50i
1080/23.98psF (Only for HDL-45E1.)
1080/24psF (Only for HDL-45E1.)
1080/25psF
1080/29.97psF
Once the menu is closed, the engineering menu cannot be opened.
When changing the scanning format again, please perform the
o p e r a t i o n 1 t o o p e n t h e e n g i n e e r i n g m e n u a n d p e r f o r m t h e
operation 2 - 5.
Scanning format
Scanning format