Table of Contents
Advertisement
5 - 14
5. OPERATION
5. Turn the MENU select switch to select the desired character and press it.
One character is set for a file name.
Be sure to use 12 characters for a file name. Use blanks (□) if a file name is shorter. The file name setting mode cannot be
completed if the file name has 11 characters or less.
[Verifying extender]
Displays the state of a lens with extender.
1. On "MENU PAGE3," turn the MENU select switch to select "LENS SELECT" and press it. The sub menu of "LENS
SELECT" is displayed.
2. Turn the MENU select switch to select "EXTENDER" and press it. The blinking cursor moves to the mode.
3. Verify the lens state. One of the following states is displayed.
• OFF: Lens other than one with extender
• ON: Lens with extender
[Automatic switchover of lens file number]
Automatically switches over the lens file number according to the model name obtained from the lens.
1. On "MENU PAGE3," turn the MENU select switch to select "LENS SELECT" and press it. The sub menu of "LENS
SELECT" is displayed.
2. Turn the MENU select switch to select "AUTO SEL" and press it. The blinking cursor moves to the mode.
3. Turn the MENU select switch to select the desired value and press it.
• OFF: Does not switch over lens file number automatically.
• ON: Switches over lens file number automatically.
Notice
[Making lens file]
Make a lens file.
Check the following in making a lens file.
• Creating a lens file requires precise adjustment. Do not update a lens file without discretion.
• Prepare a uniform white chart on which Kent paper is stuck as a subject. A registration chart is inappropriate as a subject.
• Adjust the illumination for uniform brightness of the imaging surface of the chart by using an illumination meter.
• In making a lens file, verify that a special effect filter is not attached in front of the lens or to the built-in filter disk. If a special
effect filter is attached, a lens file may not be made properly.
• In making lens files, prepare everything, including all the target lenses and make lens files at a breath under the same
conditions and environment. Precise settings cannot be performed if the conditions or environment change during creation.
When "AUTO SEL" is set to "ON," "(AUTO SEL)" is displayed after
the lens file number in the "NUMBER" row.
Advertisement
Table of Contents
