Ikegami HDL-45E Operation Manual page 34

5 - 6 5. OPERATION
[MENU PAGE2]
1. "MENU PAGE2" contains eight items: "GAIN," "GAMMA," "FLARE," "PED," "WHITE SHADE," "WHITE CLIP,"
"DTL," and "H PHASE CONTROL."
2. To select the desired item, turn and press the MENU select switch while the item is blinking. The sub menu screen of the
selected item is displayed.
3. If the MENU select switch is pressed while "EXIT" is blinking, the menu will turn off.
GAIN
GAMMA
FLARE
PED
WHITE SHADE
WHITE CLIP
DTL
H PHASE CONTROL : Adjusts level phase when external synchronization signal is
■ GAIN
GAIN
QUIT
M CLR
＊＊＊ MENU PAGE2 ＊＊＊
NEXT PAGE
GAIN
GAMMA
FLARE
PED
WHITE SHADE
WHITE CLIP
DTL
H PHASE CONTROL
EXIT
: Adjusts gain of G/B/R.
: Adjusts gamma of M/B/R.
: Adjusts flare of G/B/R/M.
: Adjusts PED of M (MASTER)/B/R.
: Adjusts white shading of H rate and V rate of G/B/R.
: Adjusts white clip of G/B/R.
: Adjusts GAIN/FREQUENCY/BLACK WHITE/BALANCE/
THRESH/FINE/NOISE SUP.
input.
B
G
0
0
CAUTION Changing G GAIN changes the sensitivity of the camera.
In normal use, the value of G GAIN should remain 0
(factory set value).
If the MENU select switch is
pressed while any of "G," "B,"
or "R" is blinking, the value
below it can be changed.
Selecting M CLR makes the
system to be set back to the
factory setup.
R
0 (-100 to +100)