Ikegami HDL-45E Operation Manual page 72

5 - 44 5. OPERATION
② When [C.TEMP SETTING BLUE] is selected, the menu is displayed as shown below.
Changes the B ch side correction range of [PRESET] in [ATW MODE].
・BLUE LIMIT AUTO SET
・BLUE LIMIT CONTROL
・BLUE LIMIT INIT
③ When [ATW REFERENCE] is clicked, the menu is displayed as shown below.
・Adjusts the color converged when the color whose color temperature is low (Red) is
・Approx. ±10％ of the red level can be adjusted by ±100 adjustment.
・Adjusts the color converged when the color whose color temperature is low (Blue) is
・Approx. ±10％ of the blue level can be adjusted by ±100 adjustment.
C．TEMP SETTING BLUE
QUIT
BLUE LIMIT AUTO SET
BLUE LIMIT CONTROL
BLUE LIMIT INIT
PUSH SET → START
1. Sets ATW MODE to PRESET, and shoots the blue subject for matching.
2. Sets [BLUE LIMIT AUTO SET] to ON, and executes [PUSH SET START].
3. When COMPLETE is displayed, the color temperature (Blue) of ATW allowed is
changed within the range of color temperature of the subject.
Enables the fine adjustment of the ATW allowable range.
By + direction, enables to broaden the ATW allowable range of the color whose color
temperature is low (Blue).
By - direction, enables to narrow the ATW allowable range of the color whose color
temperature is low (Blue).
Setting ON makes the ATW allowable range of the color whose PRESET color
temperature is low (Blue) to be set back to the factory setup.
ATW REFERENCE
QUIT
ATW RED REFERENCE
ATW BLUE REFERENCE
matched at [ATW RED REFERENCE]. (-100 to +100)
matched at [ATW RED REFERENCE]. (-100 to +100)
(ON, OFF)
ON
0 (-100 to +100)
OFF (ON, OFF)
0 (-100 to +100)
(-100 to +100)
0