Ikegami HDL-45E Operation Manual page 43

1. Connect the remote control panel.
2. On "MENU PAGE3," turn the MENU select switch to select "LENS SELECT" and press it. The sub menu of "LENS
SELECT" is displayed.
3. Turn the MENU select switch to select "NUMBER" and the desired lens file number and press it. Select No.2 or later since
the factory set data is set for No.1.
4. Verify the lens state for the "EXTENDER" setting mode. Change the setting, if necessary, referring to [Verifying extender]
described above.
5. Turn the MENU select switch to select "FILE SET" and press it. The blinking cursor moves to the mode. Turn the MENU
select switch to select "MANUAL" and press it. A "LENS No.x" message is displayed on the lower side of the screen.
6. Adjust lens file items such as GAIN, FLARE, and GAMMA using the remote control panel and press the MENU select
switch. In case of a serial-interface-capable lens, advance to procedure M1 and M2 to automatically obtain the model name
and the like from the lens.
7. Turn the MENU select switch again to select "FILE SET" and press it. The blinking cursor moves to the mode. Turn the
MENU select switch to select "OFF" and press it. At this state, the data is stored in the lens file and the file creation is
completed.
M1.Turn the MENU select switch to select "( )" for automatically obtaining and displaying the model name from the lens and
press it. The display changes to "MODE CANCEL" to obtain the new model name from the lens.
M2.Turn the MENU select switch to change the display from "MODE CANCEL" to "MODE AUTO READ" and press it.
* "COMPLETED" is displayed on the lower side of the screen.
* When "COMPLETED" disappears, the newly read model name is displayed.
Then, advance to procedure 7 described above.
Notice
If the new model name cannot be read, "READ ERROR" is displayed in place of
"COMPLETED" on the lower side of the screen.
• In procedure M2, turning the MENU select switch to change the display from
"MODE CANCEL" to "CLR" and pressing it displays "COMPLETED" on the lower
side of the screen.
• W h e n " C O M P L E T E D " d i s a p p e a r s n e x t , n o t h i n g i s d i s p l a y e d i n t h e p l a c e f o r
displaying the model name automatically obtained from the lens.
[Reading lens file]
1. On "MENU PAGE3," turn the MENU select switch to select "LENS SELECT" and press it. The sub menu of "LENS
SELECT" is displayed.
2. Turn the MENU select switch to select "NUMBER" and press it. The blinking cursor moves to the mode. Select the desired
lens file number (No.1 to No.8) to read the data out.
5. OPERATION 5 - 15