Ikegami HDL-45E Operation Manual page 41

■ LENS SELECT
QUIT
NUMBER
NAME
(
EXTENDER
AUTO SEL
FILE SET
NUMBER
NAME (
(
EXTENDER
AUTO SEL
FILE SET
● Lens file
The color balance changes resulting from differences in the optical properties of lenses are stored in a lens file. Up to eight lens
files are available and two statuses - extender OFF and extender ON - can be stored in each file. The data is selected
automatically by answer signals from the lens. White shading, flare, gain and gamma are stored in a lens file. When the HDL-
45E/E1 is shipped, the compensation data based on the factory standard lens is registered in No. 1.
[Setting lens file name]
Set a file name for each lens file. It is recommended to use the model name of the lens and the like for easy identification. Use
12 characters for a file name.
1. On "MENU PAGE3," turn the MENU select switch to select "LENS SELECT" and press it. The sub menu of "LENS
SELECT" is displayed.
2. Turn the MENU select switch to select "NUMBER" and press it. The registered lens file numbers (OFF, No.1 to No.8) are
displayed.
3. Turn the MENU select switch to select the desired lens file number and press it. Set a file name for No.2 and later since the
factory set data is set for No.1.
4. Turn the MENU select switch to select "NAME" and press it.
The blinking cursor moves to the mode and the mode changes to the character entry mode. Turning the MENU select switch
changes the character to be entered as shown below.
□ABCDEFGHIJKLMN□OPQRSTUVWXYZ□CH : . −＋／□0123456789
LENS SELECT
NO. 1
( )
)
OFF
OFF
OFF
: OFF: No lens file is registered.
No.1 to No.8: Indicates the lens file number.
) : Manually enter a file name for each lens file.
) : Displays the model name automatically obtained from the lens
when a serial-interface-capable lens is used.
: OFF : Indicates lens other than one with extender.
ON : Indicates lens with extender.
: OFF : Displays lens file setting manually.
ON : Recognizes the registered file automatically when the serial
lens is attached.
: OFF : Does not create lens file.
MANUAL: Saves the current state as lens file.
□ indicates a blank.
Clockwise
Counterclockwise
5. OPERATION 5 - 13