Ikegami HDL-45E Operation Manual page 38

5 - 10 5. OPERATION
■ WHITE CLIP
WHITE CLIP
QUIT
M CLR
■ DTL
GAIN
FREQUENCY
BLACK WHITE
BALANCE
THRESH
FINE
NOISE SUP
Selecting "M CLR" makes the system to be set back to the factory setup.
■ H PHASE CONTROL
H PHASE
QUIT
M CLR
B R
G
0 0
0
DTL
QUIT
0
GAIN
17.0
FREQUENCY
BLACK WHITE 0
0
BALANCE
THRESH 0
2
FINE
NOISE SUP 0
M CLR
: Adjusts correction volume of outline.
: Adjusts central frequency.
The higher the frequency becomes, the narrower the width of edge
signal becomes.
: Adjusts the balance of edge volume between the light part and the
dark part.
: Adjusts the balance of edge volume between horizontal direction
and vertical direction.
: Adjusts the lower level of the video signal for input.
: Adjusts the volume for increasing edges attached to minute objects
and decreasing edges attached to objects whose luminance
difference is great.
: Adjusts DTL GAIN.
SELECT
If the MENU select switch is
pressed while any of "G," "B,"
or "R" is blinking, the value be-
low it can be changed.
Selecting "M CLR" makes the
system to be set back to the
factory setup.
(-100 to +100)
(-100 to +100)
(13.0, 14.0, 15.0, 16.0, 17.0, 18.0,
20.0, 22.0, 24.0)
(-100 to +100)
(-100 to +100)
(-100 to +100)
(0, 1, 2, 3, 4, 5, 6, 7, 8)
(-100 to +100)
If the MENU select switch is
pressed while "SELECT" is
blinking, the value below it can
be changed.
Selecting "M CLR" makes the
system to be set back to the
factory setup.
0 (-100 to +100)